5/32" Aluminum Button Stop (Bag Qty. of 100)

Sleeve and Button Swaging Instructions

Before using this tool, examine and ensure that the bolt and nut of the swager are tight.

Cut cable to the required length and lace the cable through the sleeve so that the end will still protrude after crimping.

Properly insert sleeve into he correct cavity and line up the sleeve between the swager jaws with the long axis perpendicular to the jaws.

Swaging Sleeves

Swage each sleeve with the correct number of swages listed in the table below following the swage sequence shown below.

Lap splices can be made by 2 oval sleeves. Keep a short space between the sleeves.

A stopper can be made by crimping a button stop sleeve.

Each HIT Swager has a gauge. Check a crimped sleeve with the gauge. If the presses portion won't go into the gauge freely, press the sleeve completely again.