Operating Instructions

• Rope Reeving:
  • Hold the machine in one hand, with its head downward, and push the release handle
  • After hearing a noise click, the grip jaws open and clean wire rope can be reeved to a desired length
  • Push the release handle downward by hand to allow grip jaws to clamp the rope
  • When pulling the forward handle back and forward, the rope inlet or outlet shows that the unit works normally
  • Start the operation
• Anchoring:
  • Fixed axis is to be used to anchor the rope around it
  • The other tip of the rope is tied to the load
  • After the fixed axis is inserted into the machine case it must be turned twice
  • Start operation until the second tunnel is obstructed
  • Let the rope tip expose above the fixed axis to ensure the rope travels normally
• Operating - Hook the load and operate as follows:
  • To lift a load (or push a load backward) or tension it: Push the forward handle
  • To lower a load (or pull a load backward): Pull the backward handle
  • To stop working: To stop pulling the handle will stop the load at that position whether lifting or lowering it
• Drawing Rope - Once work is finished:
  • Push the release handle
  • Open the grip jaws and draw the rope out
  • Press down on the release handle to close the grip jaws