3/16 in. aluminum stops. Max After Swage Dimension: 0.350 in. Bag quantity of 100.
If properly swaged the termination efficiency for the aluminum button stop will be 33% - 50%.
Aluminum Button Stops are not recommended for use with stainless steel cable.
Features
Reviews
When will it arrive?
Orders ship same day if placed before 2PM CT. All items in your cart must be listed as In Stock. Place separate orders on in-stock and back ordered items if you want same day shipping. Applies to UPS shipping methods only, LTL Freight may go out same day if carrier pick-up schedule permits.
Before using a the swager, examine and ensure that the bolt and nut of the swager are tight.
Cut cable to the required length and lace the cable through the sleeve so that the end will still protrude after crimping.
Properly insert sleeve into he correct cavity and line up the sleeve between the swager jaws with the long axis perpendicular to the jaws.
Swage each sleeve with the correct number of swages listed in the table below following the swage sequence shown below.
Lap splices can be made by 2 oval sleeves. Keep a short space between the sleeves.
A stopper can be made by crimping a button stop sleeve.
Here is a basic chart that'll help you select the correct cavity and swager as well as how many swages to make per button.
Check a crimped sleeve with a gauge. If the presses portion won't go into the gauge freely, press the sleeve completely again.
© Copyright E-Rigging.com. All Rights Reserved. Images and content on this site are property of E-Rigging.com and shall not be used elsewhere. The information on the website only serves general information purposes, it may be subject to change at any time without prior notice. Privacy Policy
