Orders ship same day if placed before 2PM CT. All items in your cart must be listed as In Stock. Place separate orders on in-stock and back ordered items if you want same day shipping. Applies to UPS shipping methods only, LTL Freight may go out same day if carrier pick-up schedule permits.
Wire Rope Clip - Malleable iron type for 1/4 in. dia. wire rope zinc plated. Nut Size: 1/2 inch. Warning: Not to be used for overhead lifting applications. Malleable cast iron clips should only be used in non-critical applications. ASME, OSHA, and ASTM recommend only forged clips for critical applications.
Termination Efficiency Rating: 80%
In order to achieve maximum strength on vinyl coated cable, please remove the vinyl coating from the cable in the area where the wire rope clip, sleeve, or button will be affixed. When selecting termination fittings for vinyl coated cable, select the fitting that is sized to the diameter of the cable, not the diameter of the coating. If you affix the termination fitting over the vinyl coating, the strength of the assembly will be greatly reduced.
Wire Rope Clip Installation
It is important to ensure wire rope clips are installed properly. Incorrect installation can reduce the working load limit by 40%. Below are general guidelines for installing wire rope clips.
Parts of a Wire Rope Clip & Assembly
Clip Installation Diagram
Below is a diagram showing proper clip installation it is imperative that you install the saddle on the live end of the wire rope. An easy to remember saying to help remember proper clip installation is: