1/2" Drop Forged Wire Rope Clip

0 Review(s) 0 Review this item

0 Questions

Ask a Question

$2.09

InStock

SHIPS TODAY More Available Soon

Qty.

Product Specs	Part No. 51302101
Material	Hot Dip Galvanized Steel
Weight	0.73 lb

Description

Wire Rope Clip - Drop forged steel Galv. type for 1/2 in. diameter wire rope. Nut Size: 7/8 inch. Note: U-Bolt and Nuts are Zinc Plated.

Termination Efficiency Rating: 80%

Spec Sheet
Special Instructions

Spec Sheet

half-inch-Wire-Rope-Clip-specification-diagram

Name	Value
U-Bolt Diameter (A):	0.5 inches
U-Bolt Inside Height (B):	1.88 inches
Saddle Bottom to U-Bolt Bottom (C):	1 inches
U-Bolt Center to Center (D):	1.19 inches
Saddle Height (E):	1.06 inches
Saddle Width (F):	1.81 inches
Saddle Length (G):	2.31 inches

Special Instructions

In order to achieve maximum strength on vinyl coated cable, please remove the vinyl coating from the cable in the area where the wire rope clip, sleeve, or button will be affixed. When selecting termination fittings for vinyl coated cable, select the fitting that is sized to the diameter of the cable, not the diameter of the coating. If you affix the termination fitting over the vinyl coating, the strength of the assembly will be greatly reduced.

Wire Rope Clip Installation

It is important to ensure wire rope clips are installed properly. Incorrect installation can reduce the working load limit by 40%. Below are general guidelines for installing wire rope clips.

Parts of a Wire Rope Clip & Assembly

Clip Installation Diagram

Below is a diagram showing proper clip installation it is imperative that you install the saddle on the live end of the wire rope. An easy to remember saying to help remember proper clip installation is:

NEVER SADDLE A DEAD HORSE!