Features
Spec Sheet
Oval Sleeve - 5/16 inch size, Stainless Steel, Type 316.
In order to achieve maximum strength on vinyl coated cable, please remove the vinyl coating from the cable in the area where the wire rope clip, sleeve, or button will be affixed. When selecting termination fittings for vinyl coated cable, select the fitting that is sized to the diameter of the cable, not the diameter of the coating. If you affix the termination fitting over the vinyl coating, the strength of the assembly will be greatly reduced.
Sleeve and Button Swaging Instructions
Before using this tool, examine and ensure that the bolt and nut of the swager are tight.
Cut cable to the required length and lace the cable through the sleeve so that the end will still protrude after crimping.
Properly insert sleeve into he correct cavity and line up the sleeve between the swager jaws with the long axis perpendicular to the jaws.
Swaging Sleeves
Swage each sleeve with the correct number of swages listed in the table below following the swage sequence shown below.
Lap splices can be made by 2 oval sleeves. Keep a short space between the sleeves.
A stopper can be made by crimping a button stop sleeve.
Each HIT Swager has a gauge. Check a crimped sleeve with the gauge. If the presses portion won't go into the gauge freely, press the sleeve completely again.
Recommended Swage Tool: Electric Powered Hydraulic Swager
© Copyright E-Rigging.com. All Rights Reserved. Images and content on this site are property of E-Rigging.com and shall not be used elsewhere. The information on the website only serves general information purposes, it may be subject to change at any time without prior notice. Privacy Policy