1/8" Stainless Steel Jaw x Swageless Turnbuckle

Swageless Fitting Installation Instructions

(View PDF)

1. Unscrew the cone (bottom housing) and take out the jaw and the copper washer.
   • 
   • Note: The 3 piece jaw has a wire ring to keep them together.
2. Insert the cable from the bottom of the housing and place the jaw with the tapped end toward the housing (make sure the 3 piece jaw spreads around the cable evenly), place the copper washer after the jaw, the cable should protrude about 1/8" beyond the copper washer.
• 
3. Carefully push the jaws, the washer and the cable all together toward the bottom of the housing. Make sure the cable is still 1/8" out from the washer when the jaw has reached at the bottom of the housing.
• 
4. Screw the head of the fitting to the housing until it stops.
• 
5. Use two proper size wrenches, one on the housing and the other one on the head of the fitting and start to tighten in opposite directions as far as possible.
• 
6. Screw and tighten the lock nut toward the housing.
• 

Cable Railing Tension Sequence

View Older Model Swageless Fitting PDF