Cart0 item(s) in cart/ Total: $0

HIT Tools Premium 14" Hand Swager w/Cable Cutter, Swages up to 1/8"

Part Number:91600000
HIT Tools Premium 14" Hand Swager w/Cable Cutter, Swages up to 1/8"


In Stock


Not For Use with Specialty Stainless Steel Cable Railing Fittings

Premium hand swager. Model 22-ST14C with cable cutter. Length: 14 in. For swaging 1/16, 3/32 & 1/8 in. oval aluminum & copper sleeves and aluminum buttons. Maximum cable cut is 1/8. Includes Go-No Go Gauge for checking proper after swage dimensions.

These Swagers are NOT to be used for Specialty Stainless Steel Cable Railing Components, please use E-Rigging’s Stainless Steel Hand Swage Tools.

Swaging Instructions

  1. Before using this tool, examine and ensure that the bolt and nut of the swager are tight.
  2. Cut cable to the required length and lace the cable through the sleeve so that the end will still protrude after crimping.
    Hit Tools Swaging Instructions
  3. Properly insert sleeve into he correct cavity and line up the sleeve between the swager jaws with the long axis perpendicular to the jaws.
    Cable Crimping Instructions
  4. Swaging Sleeves
    1. Swage each sleeve with the correct number of swages listed in the in the table below following the swage sequence shown below.
      Wire Rope Crimp Instructions
      Cable Diameter Swages Per Oval Sleeve
      1/32" 1
      3/64" 1
      1/16" 1
      3/32" 2
      1/8" 3
      5/32" 3
      3/16" 3
      1/4" 3 or 4
      5/16" 3 or 4
      3/8 3 or 4
    2. Lap splices can be made by 2 oval sleeves. Keep a short space between the sleeves.
      Cable Lap Splice Instuctions
    3. A stopper can be made by crimping a button stop sleeve.
      Cable Button Stop Swaging Instructions
  5. Check a crimped sleeve with the gauge. If the presses portion won't go into the gauge freely, press the sleeve completely again.
    Cable Crimping Gauge Instructions


10.00 lb

Recently Viewed Items